Licensed NC Electrical Contractor · #SP.SFD.39353

Lighting Installation in Winston-Salem, NC

Recessed LEDs, fixture changeouts, ceiling fans, and exterior lighting, installed cleanly, dimmed properly, wired to code.

Call 336-283-6290 Get a Free Quote

Linear glass chandelier installed over a dining table on a shiplap ceiling
Ceiling fan installed on a vaulted shiplap ceiling in a living room
  • Lighting WorkRecessed lighting, fixture changeouts, LED retrofits, exterior lighting
  • Code ComplianceWired and supported to code, GFCI protection where the NEC requires it
  • LicensedLicensed NC Electrical Contractor · #SP.SFD.39353
  • Service AreaWinston-Salem, Clemmons & Kernersville
Linear chandelier lighting a dining room with a wall of windowsFixture changeout over an open living space with recessed cans in the ceiling

Good lighting changes how a home feels and works, and bad wiring behind a fixture is one of the most common problems we find in older Winston-Salem and Ardmore houses. We install recessed lighting, swap fixtures, retrofit LEDs, and add exterior lighting, all wired and supported to code.

Recessed Lighting Done Right

Modern canless LED wafer lights install cleanly in finished ceilings with minimal drywall work, run cool, and dim smoothly on the right dimmer. We lay out spacing for even coverage, use IC-rated fixtures where insulation contact requires it, and put the lights on properly rated dimmers. Mismatched LED dimmers are the source of most flicker complaints we get called for.

Recessed downlights washing a tray ceiling in an open living space
Pendant lights over a kitchen island and a ceiling fan in the living space beyond

Fixture Changeouts and Ceiling Fans

We install fan-rated boxes and braces where needed, and we’ll tell you when an old box behind the fixture needs replacing rather than quietly reusing it.

Landscape and facade lighting on a home at dusk, with path lights along the walkway

Exterior and Landscape Lighting

Porch lights, floods, motion security lighting, and low-voltage landscape runs, installed with weatherproof boxes, in-use covers, and GFCI protection where the NEC requires it.

Pendant lights hung in a run over a kitchen island

Frequently Asked Questions

How much does recessed lighting cost to install?

Canless LED recessed lights in a finished ceiling typically run $100–$200 per light installed, depending on attic access and switching. A written quote comes first, always.

Why do my LED lights flicker on the dimmer?

Usually an incompatible dimmer: older incandescent dimmers don't regulate LED drivers properly. Replacing it with a listed LED-compatible dimmer fixes most flicker and buzzing complaints.

Can you install a ceiling fan where a light fixture is now?

Yes, but the electrical box matters: fans require a fan-rated box or brace. We check what's behind the fixture and install the proper support. That's the difference between a safe install and a hazard.

Other Services We Provide

Level 2 EV charger installed on a garage wallEV Charger Installation Open load center with hand-labelled branch circuitsPanel Upgrades Whole-home surge protective device at the meter and load centerWhole-Home Surge Protection Amped Up electrician working at an open load center on a residential wiring jobResidential Wiring Finger pressing a smart lighting keypad on a wallSmart Home & Lutron Panels and conduit along a basement wall on an Amped Up jobAbout Amped Up

Request a Free Quote

Call 336-283-6290, email ampedupinfo@yahoo.com, or send the form below. We respond fast, usually the same day.

⚡ Tap to Call 336-283-6290 · Free Quote